| These specifications describe a self-contained patch unit which is permanently mounted to a truck chassis to be used for patching with hot asphalt.
CONTAINER
The unit shall be 4-cubic yards.
Double wall constructed.
2"- 6 lb. density insulation throughout.
3/16 GA HR interior sides, 12 GA HR exterior.
Interior walls of loading lids have expansion corrugations.
Flame cut upper pivot arms for opening top lids.
Top loading doors are 2" double walls constructed.
Doors hydraulically operate 2" x 11" stroke cylinders.
Material funneled to center of container.
Hydraulic controls located at right rear corner.
Material discharged by auger conveyor system.
Auger shall be 10 feet in length.
Auger to be supported at each end with sealed bearings.
Single speed hydraulic motor.
Forward and reverse controls.
Unit shall have an asphalt agitator.
Shaft designed to break asphalt, Bridging due to vibratory compaction.
Flanged bearings each end of shaft, driven by a hydraulic motor.
ASPHALT HEATER
Interior heat chamber has passageways to direct heat.
Chamber totally enclosed inside container.
Controlled by thermostat range of 100° to 300° degrees F.
Low density electric heating elements
Rain tight control panel.
Overnight heating requires connecting to shop 220/230 VAC single-phase circuit.
In service heating is powered by on board hydraulically powered electric generator.
HAND TORCH
Pilot with valve control.
Capacity of 200,000 BTU.
25 foot hose supplied.
SHOVELING APRON - MODEL 5
Constructed of 10 GA HR steel.
Folding bottom for material to bypass freely.
Mounted on rear of container.
COMPACTOR PLATE
Wacker WP1550BW
COMPACTOR LIFT PLATFORM
Hydraulic platform located at rear unit.
Constructed of 3/16 HR angle frame.
Cylinder 1 1/2" x 18" stroke.
HYDRAULIC TOOLS
Stanley BR67 Breaker.
Asphalt cutter.
Detachable shank with pad.
HYDRAULIC TOOL CIRCUIT
25 foot dual hose.
Quick couplers.
Flow meter.
Engine throttle meter.
Relief valve.
Pressure gauge.
TOOL BOX
Lockable, 19"W x 36"L x 19"H.
SPOILS BIN
1 cubic yard, cross frame spoils bin, 24 inches wide.
Constructed of 10 GA HR steel doors on each side to discharge material.
HOSE REELS
Emulsion spray hose reel.
Dual hose reel for jackhammer.
All reels are designed to accommodate 25 foot hoses.
LPG TANK
10 gallon upright (portable) tank for hand torch.
GENERAL TRUCK SPECIFICATIONS - AC-5 UNITIZED PATCHER
CHASSIS
Conventional or tilt cab.
GVW - 30,000 lbs.
Wheel base conventional - 184" minimum, tilt, - 135".
Cab to axle – 126" minimum with spoils.
Section modules - 14.93
ELECTRICAL
Alternator - 55 AMP minimum.
Battery - 12 volt, 77 AMP minimum.
AXLE
Front - I beam, 9,000 lbs.
Springs - heavy duty, 5,000 lbs. minimum each side.
Rear - single speed.
Capacity - 21,000 lbs.
Springs - 10,000 lbs. with 2,600 lbs. auxiliary.
TRANSMISSION
Automatic 5 speed or standard 5 speed.
|
