| These specifications describe a self-contained patch unit which is permanently mounted to a truck chassis to be used for patching with hot asphalt.
CONTAINER
The unit shall have 8 cubic yard capacity.
Double wall constructed.
2" - 6 lb. density insulation throughout.
10 GA HR steel interior sides, 12 GA HR steel exterior.
The floor shall be 1/4 inch HR steel.
Interior walls of loading lids have expansion corrugations.
Top loading doors are 2" double wall constructed.
Flame cut upper pivot arms for top lids.
All doors hydraulically operate by 2" x 11" stroke cylinders.
Material funneled to center of container.
Hydraulic controls located at right rear corner.
The hydraulic system shall operate at 1400 PSI.
The container box shall be powered by means of a double acting hoist.
Hoist shall be a Heil 2824, class 80 rating.
RADIANT HEATER
Heat tubes located under the container.
Interior heat chamber has passage ways to direct heat.
Passage ways separate from heat chamber.
Chamber totally enclosed inside container.
Burners propane fueled.
Rating of 67,000 BTU @ pressure of 5 PSI.
Controlled by thermostat range of 100° to 300° F.
12 volt electronic igniters.
100% fuel shut off if burner is extinguished.
Burner area fully enclosed.
HAND TORCH
Pilot with valve control.
Capacity of 200,000 BTU.
25 foot hose supplied.
SHOVELING APRON
Constructed of 3/16 HR steel.
Folding bottom for material to bypass freely..
Mounted on rear of container.
1/2 cubic yard capacity.
LPG TANK
2-25 gallon upright (portable) tank
|
